Summary of cost of manufacturing expenses applied under-applied factory overhead 己分配制造费用汇总表少分配工厂制造费用
Improved Bridge Erection Equipment Applied to Urban Overhead Steel Box Girder Construction 改良型架桥机在城市高架钢箱梁施工中的应用
The two methods are applied to overhead and bottom composition control of a binary distillation column. Simulation results show that both methods are efficient. 将其用于某二元精馏塔的塔顶和塔底组分控制,仿真结果证实了本文方法的有效性。
ADMINISTRATION OVERHEADS FORECAST AND OVERHEADS 'RATE DETERMINATION CONSTRUCTION BIDDING Following technique and method is applied in my article: 1 、 Predict overhead by means of linear regression analysis. 工程投标中施工管理费测算方法的研究1、线性回归预测企业管理费,确定企业管理费率;
Applied Technology for Protecting Insulated Overhead Line from Lightning Strike Breakdown 防止架空绝缘电缆雷击断线的实用技术
The applied technology and equipment are mentioned for protecting insulated overhead line from lightning strike breakdown in this paper. 提出了一种防止配电线路架空绝缘电缆雷击断线的实用技术和装置,可有效防止架空绝缘电缆雷击断线、绝缘子损坏等事故。
Proposes a working model of OCS wire overloading in factory, which may be applied in the construction of overhead electric line instead of the working model in field. 本文提出一种接触网导线工厂化超拉的工作模型,可以作为现场超拉工作模型的替代方案,应用在接触网工程等架空输电线路的施工中。
Some safety problems arise after the remote control is applied to the hoisting machinery. A 10t overhead travelling crane using F 21 type remote control device is taken as example to show the plan of retrofit for providing safety protection. 起重设备采用遥控操作后会存在一些不安全因素,本文以F-21D型遥控器对10吨桥式起重机进行遥控改造为例,提出了对起重机进行安全保护的实施方案。
This article mainly discussed has applied the distributional overhead construction the information technology method realization to produce the disease-carrying insect expert system based on the network apple Non-Environmental Damage the question. 本文主要讨论了应用分布式架构的信息技术手段实现基于网络的苹果无公害生产病虫专家系统的问题。
This paper gives a new method for solving this frictional contact problem, discusses the Finite Element Iteration Method applied to numerical structural analysis of overhead piping systems with roller supports, and gives a practical example. 本文提出了处理这种摩擦接触情况的基本思想和分析方法,用有限元迭代法分析计算了有滚柱支架的架空热力管道系统的位移和应力。
Simulation results of this model applied to overhead crane control show its validity. 该模型用于吊车控制的仿真结果证明了其有效性。
Time-varying Input Shaping Applied to Anti-swing Control of Overhead Cranes 时变输入整形在桥式起重机防摆控制中的应用
Improving the judgement matrix analytical method by multi-object weight combination value assignment, a priority weights method, which can quantitatively estimate the priority degree of multi-objects, is obtained and applied to the planning for reconstruction of replacing overhead lines by underground cables. 在判断矩阵分析法的基础上,利用多目标权系数组合赋值方法将其改进,得到定量评价多对象优先程度的优先级权系数法,并将其应用于架空线路入地改造的控制规划中。
Calculation on Forces Applied on Conductors of HV Overhead Transmission Lines Based on VB 基于VB的高压架空线路导线受力计算
Quantization on CSI feedback can be applied to minimize the signaling overhead. 为了降低反馈信道的开销,可以对反馈的CSI进行量化。
It is pointed out that single-circuit model and calculating formula may be applied to circumstance with full ranged overhead shielding and a section of cable lead. 指出了单回路的模型和计算公式适合在全程架空进线及通过一段电缆进线的情况下使用。
PSG algorithm proposed will be applied to realize the search of commodity information of this system, experiments show that the algorithm maintain a low positioning overhead while improving the search efficiency. 将本文提出的PSG算法运用到本系统中实现对商品信息的搜索,实验表明,该算法在保持低定位开销的同时提高了搜索效率。
When precoding algorithm is applied, tradeoff has to be made between the performance gain and the signal overhead. 在设计预编码算法时,需要在算法所带来的性能增益和信令开销之间做出合适的折中。
Finally, sampling, filtering and location estimation are executed. Unlike the existing Monte-Carlo algorithms, a mobility model with error compensation is applied to filter the samples. This model can reduce the computing overhead for a large number of loop computing. 最后,进行采样、过滤和位置估计,并且改变了常用蒙特卡罗的过滤方法,使用误差补偿的运动模型进行样本过滤,避免了过滤阶段大量的循环计算开销。
Traditional clustering approaches are deal with static data sets, and when they are applied to dynamic trajectory clustering, it will reprocess all trajectories every time, including the track segment has been processed previously, so it will waste a lot of unnecessary overhead. 传统的聚类方法处理的都是静态的数据集,而用于动态的轨迹聚类时,每次都要把所有轨迹重新处理一次,包括已经处理过的轨迹段,会浪费很多不必要的开销。